User's Manual

Chapter 3 - Operation and Administration Using the CLI Managing BSs
4Motion 511 System Manual
3.8.9.1 Configuring Triggers Parameters
From the BS configuration mode, run the following command:
npu(config-bs-66053)# triggers-<trigger-name> <trigger-range>
Each Trigger is configured separately. This is the general structure of the
command.
To configure the Triggers Parameters:
Command
Syntax
npu(config-bs-66053)# triggers-<trigger-name> <trigger-range>
Privilege
Level
10
Syntax
Description
Parameter Description Presence Default
Value
Possible
Values
<trigger-name> The Trigger name. Mandatory N/A See
Table 3-3
1
below
<trigger-value> Defines the threshold
value for the Trigger.
Mandatory N/A See
Table 3-3
1
below
Command
Modes
bs configuration mode