User's Manual

Chapter 3 - Operation and Administration Using the CLI Managing BSs
4Motion 554 System Manual
Do not specify this parameter if you want to view information for all existing BSs.
To display information for all BSs, run the following command:
npu# show rf bs
3.8.15 Managing the Baseband Bandwidth
Parameter
After enabling the BS configuration mode, you can configure the Baseband
bandwidth parameter (refer to Section 3.8.15.1).
Command
Syntax
npu# show rf bs [<(1 to 16777215 StepSize 1)
Privilege
Level
1
Syntax
Description
Parameter Description Presence Default
Value
Possible
Values
<(1 to 16777215
StepSize 1)>
The BS ID
Specify a value for this
parameter if you want to
display the RF frequency
parameter of a specific BS.
Do not specify a value for this
parameter if you want to
display the RF frequency
parameter of all BSs.
Optional N/A 1-16777215
Display
Format
(for each
existing BS
if requested
for all BSs)
BSIDLSB :<value>
Frequency :<value>
Command
Modes
Global command mode