User's Manual

Chapter 3 - Operation and Administration Using the CLI Managing BSs
4Motion 559 System Manual
 Downlink Diversity (refer to Section 3.8.16.2.3)
 Uplink Feedback Zone (refer to Section 3.8.16.2.4)
 Downlink Data Zone (refer to Section 3.8.16.2.5)
 Uplink Data Zone (refer to Section 3.8.16.2.6)
 Dynamic Permutation (refer to Section 3.8.16.2.7)
 Mimo (refer to Section 3.8.16.2.8)
3.8.16.2.1 Configuring Airframe General Parameters
To configure the Airframe General parameters, run the following command:
npu(config-bs-66053-airframe)# general [cell-id <(0 to 31 StepSize 1)>]
[preamble-grp <(1 to 2 StepSize 1)>] [segment <(0 to 2 StepSize 1)>] [frame-offset
<(0 to 15 StepSize 1)>] [ul-duration <(3 to 7 StepSize 1)>]
IMPORTANT
After completing the Airframe configuration,do not forget to execute the apply command before
exiting the Airframe configuration mode:
npu(config-bs-66053-airframe)# apply
IMPORTANT
When creating a new BS, all mandatory Neighbor BS General parameters must be configured.
Command
Syntax
npu(config-bs-66053-airframe)# general [cell-id <(0 to 31 StepSize
1)> ] [preamble-grp <(1 to 2 StepSize 1)>] [segment <(0 to 2
StepSize 1)> ] [frame-offset <(0 to 15 StepSize 1)> ] [ul-duration
<(3 to 7 StepSize 1)> ]
Privilege
Level
10
Syntax
Description
Parameter Description Presence Default
Value
Possible Values