User's Manual

Chapter 3 - Operation and Administration Using the CLI Managing BSs
4Motion 563 System Manual
3.8.16.2.4 Configuring Airframe Uplink Feedback Zone Parameters
To configure the Airframe Uplink Feedback Zone parameters, run the following
command:
npu(config-bs-66053-airframe)# ulfeedbackzone [subchannels <(1 to 35
StepSize 1)>] [permbase <(0 to 69 StepSize 1)>]
Privilege
Level
10
Syntax
Description
Parameter Description Presence Default
Value
Possible
Values
mode <none |
matrixA|
matrixAorB>
The diversity mode used in
downlink transmissions .
Optional matrixA0rB
 none
 matrixA
 matrixAorB
Command
Modes
bs airframe configuration mode
NOTE
An attempt to configure the subchannels parameter will be ignored. The value of this parameter is
set by internal logic according to the configured bandwidth.
IMPORTANT
When creating a new BS, the Airframe Structure Uplink Feedback Zone mandatory permbase
parameter must be configured.
Command
Syntax
npu(config-bs-66053-airframe)# ulfeedbackzone [subchannels <(11 to 35
StepSize 1)> ] [permbase <(0 to 69 StepSize 1)> ]
Privilege
Level
10