User's Manual

Chapter 3 - Operation and Administration Using the CLI Managing BSs
4Motion 573 System Manual
3.8.16.3.3 Restoring the Default Value of Airframe Downlink Diversity Mode
Parameter
To restore the Airframe Downlink Diversity mode parameter to its default value,
run the following command:
npu(config-bs-66053-airframe)# no dldiversity mode
Since the Downlink Diversity table contains a single parameter, it is sufficient to
run the following command:
npu(config-bs-66053-airframe)# no dldiversity
3.8.16.3.4 Restoring the Default Values of Airframe Dynamic Permutation
Parameters
To restore one or all of the Airframe Dynamic Permutation parameters to their
default values, run the following command:
npu(config-bs-66053-airframe)# no dynamicperm [dl-permbase] [ul-permbase]
You can restore only one parameter to the default value by specifying only that
parameter. For example, to restore only the dl-permbase to the default value, run
the following command:
Privilege
Level
10
Command
Modes
bs airframe configuration mode
NOTE
Refer to Section 3.8.16.2.3 for a description and default values of these parameters.
Command
Syntax
npu(config-bs-66053-airframe)# no dldiversity [mode ]
Privilege
Level
10
Command
Modes
bs airframe configuration mode