User's Manual

Chapter 3 - Operation and Administration Using the CLI Managing BSs
4Motion 574 System Manual
npu(config-bs-66053-airframe)# no dynamicperm dl-permbase
The parameter will be restored to its default value, while the other parameter will
remain unchanged.
To restore all non-mandatory parameters to their default value, run the following
command:
npu(config-bs-66053-airframe)# no dynamicperm
3.8.16.3.5 Restoring the Default Values of Airframe MIMO Parameters
To restore one or all of the Airframe MIMO parameters to their default values, run
the following command:
npu(config-bs-66053-airframe)# no mimo [first-zone-min-size ]
[first-zone-max-size ] [max-map-size ] [bcast-msgzone-loc ]
To restore all MIMO parameters to their default values, run the following
command:
npu(config-bs-66053-airframe)# no mimo
NOTE
Refer to Section 3.8.16.2.7 for a description and default values of these parameters.
Command
Syntax
npu(config-bs-66053-airframe)# no dynamicperm [dl-permbase ]
[ul-permbase ]
Privilege
Level
10
Command
Modes
bs airframe configuration mode
NOTE
bcast-msgzone-loc always set to nonSTCZoneOnly.
NOTE
Refer to Section 3.8.16.2.8 for a description and default values of these parameters.