User's Manual

Chapter 3 - Operation and Administration Using the CLI Managing BSs
4Motion 587 System Manual
3.8.17 Managing BS Bearer Interface Parameters
After enabling the BS configuration mode, you can execute the following tasks:
 Configure one or more of the Bearer Interface parameters (refer to
Section 3.8.17.1).
 Restore the default values of some or all of the Bearer Interface parameters
(refer to Section 3.8.17.2).
You can display configuration information for the Bearer Interface parameters of a
selected or all existing BSs (refer to Section 3.8.17.3).
3.8.17.1 Configuring Bearer Interface Parameters
From the BS configuration mode, run the following command:
npu(config-bs-66053)# bearer [ip-address <ip address>] [ip-subnetmask <ip
address>] [dflt-gw <ip address>] [mtu-size <(1500 to 9000 StepSize 1)>]
[linkusage-hardthrshld <(1 to 100 StepSize 1)>] [bearer-vlan <(9 to 9 StepSize 1) |
(11 to 100 StepSize 1) |(110 to 4094 StepSize 1)> ]
Syntax
Description
Parameter Description Presence Default
Value
Possible
Values
<(1 to 16777215
StepSize 1)>
The BS ID
Specify a value for this
parameter if you want to
display all Airframe
parameters of a specific BS.
Do not specify a value for this
parameter if you want to
display all Airframe
parameters of all BSs.
Optional N/A 1-16777215
Command
Modes
Global command mode
To configure the Bearer Interface Parameters: