User's Manual

Chapter 3 - Operation and Administration Using the CLI Managing BSs
4Motion 594 System Manual
3.8.18.3 Displaying Configuration Information for Authentication
Parameters
To display configuration information of Authentication parameters, run the
following command:
npu# show auth-general bs [<(1 to 16777215 StepSize 1)
Specify the BS ID if you want to display information for a particular BS. For
example, to display the Authentication parameters of BS 66053, run the following
command:
npu# show auth-general bs 66053
Do not specify this parameter if you want to view information for all existing BSs.
To display information for all BSs, run the following command:
npu# show auth-general bs
NOTE
Refer to Section 3.8.18.1 for a description and default values of these parameters.
Command
Syntax
npu(config-bs-66053)# no auth-general [suspendedeapprocthrshld ]
[activemsthrshld ] [maxeaproundsthrshld ]
Privilege
Level
10
Command
Modes
bs configuration mode
Command
Syntax
npu# show auth-general bs [<(1 to 16777215 StepSize 1)
Privilege
Level
1