User's Manual

Chapter 3 - Operation and Administration Using the CLI Managing BSs
4Motion 601 System Manual
3.8.20.3 Restoring Default Values for Bearer Traffic QoS Marking
Rule Configuration Parameters
After enabling the Bearer Traffic QoS Marking Rule configuration mode you can
restore the default values for non-mandatory parameters.
To restore some or all of the Bearer Traffic QoS Marking Rule non-mandatory
parameters to their default values, run the following command:
npu(config-bs-66053-bearertrafficqos-1)# no mrkngrule [rule-status]
[rule-name] [srvcflow-datadeliverytype [srvcflow-trafficpriority] [outerdscp]
[bp8021p]
You can restore only one or several parameters to the default values by specifying
only those parameters. For example, to restore only the outerdscp to the default
value, run the following command:
npu(config-bs-66053-bearertrafficqos-1)# no mrkngrule outerdscp
The parameter will be restored to its default value, while the other parameters will
remain unchanged.
srvcflow-mediaflowty
pe <string (32)>
One of key entries into the
traffic marking rules table.
Media Flow Type should be
defined in ASN-GW or AAA
server.
Only relevant if
enable-srvcflow-mediaflowtyp
e (see below) is TRUE.
Mandatory
when
creating a
new rule (if
relevant)
N/A A string of up
to 32
characters
enable-srvcflow-med
iaflowtype {TRUE |
FALSE}
If TRUE, the
srvcflow-mediaflowtype (see
above) will be considered.
when looking for a match. If
FALSE it will not be
considered.
Mandatory
when
creating a
new rule
 TRUE
 FALSE
outerdscp <(0 to 63
StepSize 1)>
DSCP value to be used for
marking of outer IP header
(IP/GRE).
Optional 0 0 - 63
bp8021p <(0 to 7
StepSize 1)>
802.1p priority to be used for
marking of traffic
Optional 0 0 - 7
Command
Modes
bs bearer traffic qos marking rule configuration mode