User's Manual

Chapter 3 - Operation and Administration Using the CLI Managing BSs
4Motion 602 System Manual
To restore all Bearer Traffic QoS Marking Rule non-mandatory parameters to their
default value, run the following command:
npu(config-bs-66053-bearertrafficqos-1)# no mrkngrule
3.8.20.4 Terminating the Bearer Traffic QoS Marking Rule
Configuration Mode
Run the following command to terminate the Bearer Traffic QoS Marking Rule
configuration mode:
npu(config-bs-66053-bearertrafficqos-1)# exit
3.8.20.5 Deleting a Bearer Traffic QoS Marking Rule
Run the following command from the BS configuration mode to delete a Bearer
Traffic QoS Marking Rule:
npu(config-bs 66053)# no
bearertrafficqos <(1 to 16383 StepSize 1)>
NOTE
Refer to Section 3.8.20.2 for a description and default values of these parameters.
Command
Syntax
npu(config-bs-66053-bearertrafficqos-1)# no mrkngrule [rule-status ]
[rule-name ] [srvcflow-datadeliverytype [srvcflow-trafficpriority
] [outerdscp ] [bp8021p ]
Privilege
Level
10
Command
Modes
bs bearer traffic qos marking rule configuration mode
Command
Syntax
npu(config-bs-66053-bearertrafficqos-1)# exit
Privilege
Level
10
Command
Modes
bs bearer traffic qos marking rule configuration mode