User's Manual

Chapter 3 - Operation and Administration Using the CLI Managing BSs
4Motion 618 System Manual
3.8.23.2 Configuring Ranging Parameters
To configure the Ranging General parameters, run the following command:
npu(config-bs-66053-ranging)# general [start-of-rng-codes <(0 to 255 StepSize
1)>] [max-cellradius {one | two | four | eight | fifteen | twentyThree | thirty}]
Command
Modes
bs configuration mode
Command
Syntax
npu(config-bs-66053-ranging)# general [start-of-rng-codes <(0 to 255
StepSize 1)> ] [max-cellradius {one | two | four | eight | fifteen
| twentyThree | thirty} ]
Privilege
Level
10
Syntax
Description
Parameter Description Presence Default
Value
Possible
Values
start-of-rng-codes
<(0 to 255
StepSize 1)>
Start of Ranging Codes: The
starting number S of the
group of codes used for this
uplink.
Actual valid values are 0, 64,
128, 192. If a different value
is configured-the highest valid
value that is lower than the
configured value will be set
(for example, for a configured
value of 140 the actual value
will be 128).
Optional 0 0 - 255