User's Manual

Chapter 3 - Operation and Administration Using the CLI Managing BSs
4Motion 625 System Manual
3.8.24.3 Displaying Configuration Information for Alarm Threshold
Parameters
To display configuration information of Alarm Threshold parameters, run the
following command:
npu# show alrm-thrshld bs [<(1 to 16777215 StepSize 1)
Specify the BS ID if you want to display information for a particular BS. For
example, to display the Alarm Threshold parameters of BS 66053, run the
following command:
npu# show alrm-thrshld bs 66053
Do not specify this parameter if you want to view information for all existing BSs.
To display information for all BSs, run the following command:
npu# show alrm-thrshld bs
Command
Syntax
npu(config-bs-66053)# no alrm-thrshld [ul-mednoise ] [ul-99prcntnoise
] [Be-exc-dl-drop-thr ] [rt-exc-dl-drop-thr ] [nrt-exc-dl-drop-thr
] [ugs-exc-dl-drop-thr ] [ert-exc-dl-drop-thr ]
Privilege
Level
10
Command
Modes
bs configuration mode
Command
Syntax
npu# show alrm-thrshld bs [<(1 to 16777215 StepSize 1)
Privilege
Level
1