User's Manual

Chapter 3 - Operation and Administration Using the CLI Managing BSs
4Motion 635 System Manual
3.8.28.2 Restoring Default Values for the BS Idle Mode Parameters
After enabling the BS configuration mode you can restore the default values for
the BS Idle Mode idle-Mode-ms-initiated-for-ugs parameter.
To restore the BS Idle Mode idle-Mode-ms-initiated-for-ugs parameter to its
default value, run the following command:
npu(config-bs-66053)# no idle-mode
[idle-Mode-ms-initiated-for-ugs]
[paging-group-id <(0 to
65535 StepSize 1)> ]
The Paging Group ID
of the BS.
0 means that Idle
Mode is disabled.
If other than 0
(disable), should be
unique in the network
(different
paging-group for each
BS).
Mandatory 0 0 to 65535
[idle-Mode-ms-initiated-f
or-ugs {disable | enable}
]
The parameter defines
whether BS allows MS
to enter idle mode
initiated by the MS,
when there is a UGS
connection available.
If it is disabled - BS
shall always reject MS
initiation and request
to enter idle mode.
If it is enabled - BS
would approve MS to
enter the idle mode
without being able to
guarantee the
required QoS for
UGS.
Optional disable
 disable
 enable
Command
Modes
bs configuration mode
NOTE
Refer to Section 3.8.28.1 for a description and default value of this parameter.