User's Manual

Chapter 3 - Operation and Administration Using the CLI Managing BSs
4Motion 636 System Manual
3.8.28.3 Displaying Configuration Information for the BS Idle Mode
Parameters
To display configuration information of the BS Idle Mode parameters of a specific
or all BSs, run the following command:
npu# show idle-mode bs [<(1 to 16777215 StepSize 1)>]
Specify the BS ID (1-16777215) of an existing BS if you want to display
configuration information for a particular BS. Do not specify values for this
parameter if you want to view configuration information for all existing BSs.
Command
Syntax
npu(config-bs-66053)# no idle-mode
[idle-Mode-ms-initiated-for-ugs]
Privilege
Level
10
Command
Modes
bs configuration mode
Command
Syntax
npu# show idle-mode bs [<(1 to 16777215 StepSize 1)> ]
Privilege
Level
1
Syntax
Description
Parameter Description Presence Default
Value
Possible
Values
[<(1 to 16777215
StepSize 1)> ]
The BS ID
Specify a value for this
parameter if you want to
display the Idle Mode Paging
Group ID Parameter of a
specific BS. Do not specify a
value for this parameter if you
want to display the Idle Mode
Paging Group ID Parameter
of all BSs.
Optional N/A 1-16777215