User's Manual

Chapter 3 - Operation and Administration Using the CLI Troubleshooting
4Motion 668 System Manual
3.11.1.1.2 Disabling System-level Tracing
To disable tracing at the system-level, run the following command:
NOTE
After you have enabled system-level tracing, you can configure the types of traces (brief or detailed)
to be generated for each module. By default, module-level tracing is disabled. To configure tracing
for each module, refer to Section 3.11.1.2.
IMPORTANT
An error may occur if:
 Tracing is already enabled for the requested destination (file or console).
 An internal error has occurred.
Command
Syntax
npu(config)# trace destination
{file|console}
Privilege
Level
10
Syntax
Description
Parameter Description Presence Default
Value
Possible
Values
{file|console} Indicates whether tracing to a
file or console is to be
enabled for the entire system.
Mandatory N/A
 file:
Indicates
that
system-leve
l traces are
to be
written to a
file.
 console:
Indicates
that the
system-leve
l traces are
to be
written to a
console.
Command
Modes
Global configuration mode