User's Manual

Chapter 3 - Operation and Administration Using the CLI Troubleshooting

4Motion 678 System Manual

3.11.2.2 Disabling a Port Monitoring Session

You can disable a port monitoring session for a source or destinations interface

for which port monitoring is enabled. Run the following command to disable port

monitoring for a source or destination interface:

npu(config)# no monitor session [{source interface <interface-type>

<interface-id> [{ rx | tx | both }]|destination interface

<interface-type > < interface-id >}]

IMPORTANT

An error may occur if:

 The interface ID of the source or destination port you have specified is invalid. Refer

Table 3-39 for the interface ID corresponding to each interface type.

 Port monitoring is not enabled for the source or destination interface for which you are trying to

disable port monitoring.

Command

Syntax

npu(config)# no monitor session

[{source interface <interface-type>

<interface-id> [{ rx | tx | both }]|destination interface <interface-type

> < interface-id >}]

Privilege

Level