User's Manual

Chapter 3 - Operation and Administration Using the CLI Troubleshooting
4Motion 680 System Manual
3.11.2.3 Displaying Configuration Information for Source and
Destination Interfaces
To display configuration information for port monitoring, that is, the source and
destination interfaces for which this feature is enabled, run the following
command:
npu# show port-monitoring
Command
Syntax
npu# show port-monitoring
Privilege
Level
1
Display
Format
Port Monitoring: enabled
Monitor Port: Gi0/9
Port Ingress-Monitoring Egress-Monitoring
---- ------------------ ------------
Fa0/1 <status> <status>
Fa0/2 <status> <status>
Fa0/3 <status> <status>
Fa0/4 <status> <status>
Fa0/5 <status> <status>
Fa0/6 <status> <status>
Fa0/7 <status> <status>
Fa0/8 <status> <status>
Gi0/9 <status> <status>
Command
Modes
Global configuration mode