User's Manual

Appendix B - Software Upgrade Upgrading the NPU
4Motion 696 System Manual
B.2.3 Displaying the TFTP Configuration
Information
You can, at any time (during or after the download procedure), run the following
command to view the configuration information about the TFTP server that is
used for the NPU software upgrade:
npu# show software version server
B.2.4 Displaying the Download Status Information
After initiating software download, you can, at any time, view the download
progress for the NPU image. The progress of the image download procedure can be
in any of the following stages:
 Downloading
 Decompressing
 Validating
 Copying
 Writing to flash
Command
Modes
Global command mode
IMPORTANT
An error may occur if configuration information is requested for a TFTP server that is not configured.
For more information about configuring the TFTP server to be used for software download, refer to
“Step 1: Configuring the TFTP Server” on page 691.
Command
Syntax
npu# show software version server
Display
Format
Software version server <Server IP Address>
Command
Modes
Global command mode