User's Manual

Chapter 3 - Operation and Administration Using the CLI NPU Configuration
4Motion 395 System Manual
In addition to the configurable parameters, the calculated Local Time is also
displayed.
3.3.15.2.9 Displaying the Position Parameters
To display the current position parameters, run the following command:
npu# show position [{Latitude | Longitude | Altitude}]
3.3.15.2.10 Displaying the Number of Satellite Parameters
To display the current satellite parameters, run the following command:
npu# show satellite [{MinNumOfSatForHoldoverReturn |
MaxNumOfSatBeforeSyncLoss | NumOfSatelliteAvailable}]
Command
Syntax
npu# show position [{Latitude | Longitude | Altitude}]
Privilege
Level
1
Syntax
Description
For a detailed description of each parameter in this command, refer the section,
“Configuring
the Position” on page 390
.
Display
Format
Latitude :
Longitude :
Altitude :
Command
Modes
Global command mode
Command
Syntax
npu# show satellite [{MinNumOfSatForHoldoverReturn |
MaxNumOfSatBeforeSyncLoss | NumOfSatelliteAvailable}]
Privilege
Level
1
Syntax
Description
For a detailed description of each parameter in this command, refer the section, “Configuring
the Required Number of Satellites” on page 391
.