User's Manual

Chapter 3 - Operation and Administration Using the CLI NPU Configuration
4Motion 409 System Manual
3.3.15.7.2 Displaying the Site General Information Parameters
To display configuration information for the site general information parameters,
run the following command:
npu# show site [{Name | Address | RackLocation | ContactPerson
|ProductType}]
In addition to the configurable parameter (see Section 3.3.15.7.1), you can also
display the Product Type.
If you want to display configuration information for one parameter, specify only
the required parameter. If you want to display configuration information for all dry
contact alarms, run the following command:
npu# show site
3.3.15.8 Managing the Unique Identifier for the 4Motion Shelf
The Site Identifier (Site ID) is used by the management system as identifier of the
site and must be unique in the managed network.
Command
Modes
Global configuration mode
Command
Syntax
npu# show site [{Name | Address | RackLocation | ContactPerson
|ProductType }]
Privilege
Level
1
Display
Format
(for all
parameters)
Name :
Address :
Rack Location :
Contact Person :
Product Type :
Command
Modes
Global command mode