User's Manual

Chapter 3 - Operation and Administration Using the CLI NPU Configuration
4Motion 410 System Manual
The default value 0 is not a valid Site Identifier: it indicates that the Site Identifier
was not configured and a valid Site Identifier must be configured. A BTS with Site
Identifier 0 will not be discovered by AlvariSTAR.
Since the Site Identifier is used by AlvariSTAR to identify the device, it is highly
recommended not to modify it. If necessary, you must follow the Site Number
Change process described in the AlvariSTAR Device Manager User Manual.
This section describes the commands used for:
“Configuring the Unique Identifier for the 4Motion Shelf” on page 410
“Displaying the Unique Identifier for the 4Motion Shelf” on page 411
3.3.15.8.1 Configuring the Unique Identifier for the 4Motion Shelf
To configure a unique identifier for the 4Motion shelf, run the following command:
npu(config)# site identifier <site id <0-999999>>
IMPORTANT
You must save the configuration (run the command npu# write) for a change in site identifier to take
effect after next reset.
Since the site identifier (Site Number) is used by AlvariSTAR management system to identify the
device, it is highly recommended not to modify it. If necessary, you must follow the Site Number
Change process described in the Device Driver Manual.
NOTE
To display the 4Motion shelf identifer, refer to “Displaying the Unique Identifier for the
4Motion Shelf” on page 411
.
Command
Syntax
npu(config)# site identifier <
site id <0-999999>>
Privilege
Level
10
Syntax
Description
Parameter Description Presence Default
Value
Possible
Values
<
site id
<0-999999>
>
Indicates the ID of the
4Motion shelf.
Mandatory N/A 0-999999