User's Manual

Chapter 3 - Operation and Administration Using the CLI Managing AUs
4Motion 415 System Manual
3.5.1 Enabling the AU Configuration Mode\Creating
an AU Object
To configure the parameters of an AU, first enable the AU configuration mode for
the specific AU. Run the following command to enable the AU configuration mode.
You can also use this command to create a new AU object. A new AU object is
created with default values for all parameters.
npu (config)# au <(1 to 4 StepSize 1) | (7 to 9 StepSize 1)>
Specify the slot ID of the AU to be configured/created. See Figure 3-1 for slot
assignment in the shelf.
For example, to configure the AU in slot# 1, run the following command:
npu (config)# au 1
If you use this command to create a new AU, the configuration mode for this AU is
automatically enabled, after which you can execute any of the following tasks:
 Configure one or more of the parameters tables of the AU (refer to
Section 3.5.2)
 Restore the default values of parameters in one or more of the parameters
tables of the AU (refer to Section 3.5.3)
After executing the above tasks, you can terminate the AU configuration mode
(refer to Section 3.5.4) and return to the global configuration mode.
IMPORTANT
An error occurs if you specify an AU slot ID that is not in the range, 1-4, or 7-9.
Command
Syntax
npu (config)# au <(1 to 4 StepSize 1) | (7 to 9 StepSize 1)>
Privilege
Level
10
Syntax
Description
Parameter Description Presence Default
Value
Possible
Values