User's Manual

Chapter 3 - Operation and Administration Using the CLI Managing AUs
4Motion 416 System Manual
3.5.2 Configuring AU Parameters
After enabling the AU configuration mode you can configure the following
parameters tables:
 Properties (refer to Section 3.5.2.1)
 Control (refer to Section 3.5.2.2)
 Connectivity (refer to Section 3.5.2.3)
3.5.2.1 Configuring Properties
The properties table enables configuring the main properties of the required AU
card and controlling the power on each of the AU’s ODU ports.
To configure the properties parameters, run the following command:
npu(config-au-1)# properties [required-type <au4x4Modem |au2x2>]
[port-1-power {shutDown | noShutDown}] [port-2-power {shutDown |
noShutDown}] [port-3-power {shutDown | noShutDown}] [port-4-power
{shutDown | noShutDown}]
<(1 to 4 StepSize
1) | (7 to 9
StepSize 1)>
The slot ID of the AU to be
configured
Mandatory N/A
 1-4
 7-9
Command
Modes
Global configuration mode
NOTE
The following examples are for au configuration mode for au-1 .
NOTE
You can display configuration information for the AU properties. For details, refer to
Section 3.5.6.1.
IMPORTANT
An error may occur if you provide an invalid value for any of these parameters. Refer the syntax
description for more information about the appropriate values and format for configuring these
parameters.