User's Manual

Chapter 3 - Operation and Administration Using the CLI Managing AUs
4Motion 420 System Manual
3.5.3 Restoring Default Values for AU Configuration
Parameters
After enabling the AU configuration mode you can restore the default values for
parameters in the following parameters tables:
 Properties (refer to Section 3.5.3.1)
 Control (refer to Section 3.5.3.2)
 Connectivity (refer to Section 3.5.3.3)
3.5.3.1 Restoring the Default Values of Properties Parameters
To restore the some or all of the Properties parameters to their default value, run
the following command:
npu(config-au-1)# no properties [required-type] [port-1-power]
[port-2-power] [port-3-power] [port-4-power]
You can restore only selected parameters to their default value by specifying only
those parameter. For example, to restore only the port-1-power to the default
value, run the following command:
npu(config-au-1)# no properties port-1-power
The parameter will be restored to its default value, while the other parameters will
remain unchanged.
To restore all properties parameters to their default value, run the following
command:
npu(config-au-1)# no properties
[service-next-hop
<ip address> ]
The default gateway IP
address of the service
interface.
Optional 0.0.0.0
(none)
IP address
Command
Modes
au-1 configuration mode
NOTE
Refer to Section 3.5.2.1 for a description and default values of these parameters.