User's Manual

Chapter 3 - Operation and Administration Using the CLI Managing AUs
4Motion 423 System Manual
3.5.6 Displaying Configuration and Status
Information for AU Parameters
You can display the current configuration and (where applicable) additional status
information for the following parameters tables:
 Properties (refer to Section 3.5.6.1)
 Control (refer to Section 3.5.6.2)
 Connectivity (refer to Section 3.5.6.3)
3.5.6.1 Displaying Configuration and Status Information for AU
Properties
To display configuration and status information for the properties of a specific or
all AU objects, run the following command:
npu# show properties au [<(1 to 4 StepSize 1) | (7 to 9 StepSize 1)>]
Specify the au slot ID (1-4, 7-9) if you want to display configuration and status
information for a particular AU. Do not specify a value for this parameter if you
want to view configuration and status information for all existing AU objects.
Command
Syntax
npu(config)# no au <(1 to 4 StepSize 1) | (7 to 9 StepSize 1)>
Privilege
Level
10
Syntax
Description
Parameter Description Presence Default
Value
Possible
Values
<(1 to 4 StepSize 1) |
(7 to 9 StepSize 1)>
The slot ID of the AU card Mandatory N/A 1-4, 7-9
Command
Modes
Global configuration mode