User's Manual

Chapter 3 - Operation and Administration Using the CLI Managing ODUs
4Motion 432 System Manual
C = Y if cavity filter is present, N if not.
S = Reserved (0).
x
3.6.1.2 Configuring ODU Parameters
After enabling the ODU parameters configuration mode you can configure the
General ODU parameters.
The general ODU parameters table enables configuring the main properties of the
required ODU.
To configure the general ODU parameters, run the following command:
npu(config-odu-params-1)# odu-general [external-cavity-filter-existence
{TRUE | FALSE} ] [required-odu-type {<a list of ODU types>} ]
NOTE
1 The list includes ODUs that are not available yet.
2 For oDU23052360000N361by1Y0 that includes a WCS filter, the actually supported frequency
band is 2305 - 2317, 2348 - 2360 MHz.
3 For the oDU24852690000N384by2NO the maximum supported transmit power in the
2485-2495 MHz band is 37 dBm.
NOTE
The following examples are for odu-1 parameters configuration mode.
NOTE
You can display configuration information for the ODU general parameters. For details, refer to
Section 3.6.1.6.
IMPORTANT
An error may occur if you provide an invalid value for any of these parameters. Refer the syntax
description for more information about the appropriate values and format for configuring these
parameters.
Command
Syntax
npu(config-odu-params-1)# odu-general
[external-cavity-filter-existence {TRUE | FALSE} ]
[required-odu-type {<a list of ODU types} ]