User's Manual

Chapter 3 - Operation and Administration Using the CLI Managing Antennas
4Motion 445 System Manual
After enabling the configuration mode for an Antenna you can execute any of the
following tasks:
 Configure one or more of the parameters of the Antenna (refer to Section 3.7.2)
 Restore the default value of the non-mandatory parameters parameter (refer to
Section 3.7.3)
After executing the above tasks, you can terminate the Antenna configuration
mode (refer to Section 3.7.4) and return to the global configuration mode.
3.7.2 Configuring Antenna Parameters
After enabling the Antenna configuration mode you can configure the Antenna
parameters.
To configure the Antenna parameters, run the following command:
npu(config-antenna-1)# params [antenna-type <string (32)>] [no-of-ports <(1 to 8
StepSize 1)>] [mechanical-downtilt <(-90 to 90 StepSize 0.1)>] [electrical-downtilt
<(-90 to 90 StepSize 0.1)>] [longitude <longitude>] [latitude <latitude>]
[tower-height <(0 to 500 StepSize 1)>] [heading <(0 to 359 StepSize 1)>] [cable-loss
Command
Syntax
npu (config)# antenna <(1 to 28 StepSize 1)>
Privilege
Level
10
Syntax
Description
Parameter Description Presence Default
Value
Possible
Values
<(1 to 28 StepSize 1)> The Antenna number Mandatory N/A 1-28
Command
Modes
Global configuration mode
NOTE
The following examples are for antenna-1 configuration mode.