User's Manual

Chapter 3 - Operation and Administration Using the CLI NPU Configuration
4Motion 262 System Manual
3.3.11.14.4.2.5Terminating the DHCP Server Configuration Mode
Run the following command to terminate the DHCP server configuration mode:
npu(config-srvcgrp-dhcpserver)# exit
Privilege
Level
10
Syntax
Description
Parameter Description Presence Default
Value
Possible
Values
<no. of Addrs
(1-9)>
The number of excluded IP
addresses to be deleted.
Do not specify any value if
you want to remove all the
exclude IP addresses
specified for that DHCP
server.
Optional N/A 1-9
<ipv4addr> Denotes an IP address that
you want to remove from the
list of exclude IP addresses.
The number of IP address
entries must match the value
defined by the no. of Addrs
parameter.
Do not specify any value if
you want to remove all the
exclude IP addresses
specified for that DHCP
server.
Optional N/A Valid IP
address
Command
Modes
Service group-DHCP server configuration mode
Command
Syntax
npu(config-srvcgrp-dhcpserver)# exit
Privilege
Level
10