User's Manual

Chapter 3 - Operation and Administration Using the CLI NPU Configuration
4Motion 267 System Manual
3.3.11.14.4.3.3Terminating the DHCP Proxy Configuration Mode
Run the following command to terminate the DHCP proxy configuration mode:
npu(config-srvcgrp-dhcpproxy)# exit
3.3.11.14.4.4 Configuring the DHCP Relay
After enabling the service group operation mode for the DHCP relay, you can
execute any of the following tasks:
 “Configuring the DHCP Relay Parameters” on page 267
 “Terminating the DHCP Relay Configuration Mode” on page 272
3.3.11.14.4.4.1Configuring the DHCP Relay Parameters
Run the following command to configure the DHCP server address for the DHCP
relay:
npu(config-srvcgrp-dhcprelay)# config ([server-addr <ipV4Addr>]
[{EnableOpt82|DisableOpt82}])
Command
Syntax
npu(config-srvcgrp-dhcpproxy)# no [offerreuse-holdtime] [lease-interval]
[dnssrvr-addr][renew-interval] [rebind-interval] [dnssrvr-addr2]
Privilege
Level
10
Command
Modes
Service group-DHCP proxy configuration mode
Command
Syntax
npu(config-srvcgrp-dhcpproxy)# exit
Privilege
Level
10
Command
Modes
Service group-DHCP proxy configuration mode