User's Manual

Chapter 3 - Operation and Administration Using the CLI NPU Configuration
4Motion 271 System Manual
3.3.11.14.4.4.3Removing the DHCP Relay suboption values
Run the following command to remove one, several or all of the Suboption values
configured by the user for DHCP Option 82.
npu(config-srvcgrp-dhcprelay-opt82)# no [Subopt1value] [Subopt2value]
[Subopt6value] [Subopt7value]
[{Subopt7value
[service-type]
[vendor-specific
]
[session-timeo
ut]}]
Configures the suboption 7 of
DHCP option 82.
Allows
enabling/disabling the
use of suboption 7 by
specifying it. In
addition, allows
enabling/disabling the
following attributes (by
specifying attributes to
be enabled) if suboption
7 is enabled:

service-type (attribute 6)
 vendor-specific (attribute
26)
 session-timeout (attribute
27)
Optional
[{EnableUnicas
t|DisableUnica
st}])
Indicates whether the
Unicast parameter is
enabled or disabled.
Optional Disable
 Enable
 Disable
Command
Mode
Service group-DHCP relay-option 82 configuration mode
Command
Syntax
npu(config-srvcgrp-dhcprelay-opt82)# no [Subopt1value] [Subopt2value]
[Subopt6value] [Subopt7value]
Privilage
Level
10