User's Manual

Chapter 3 - Operation and Administration Using the CLI NPU Configuration
4Motion 278 System Manual
To configure the start vlan id run the command:
npu(config-srvcgrp-VPWS-Mapped)# config vid-map-range-start vlan-id
<size(1-4094)>.
To configure the end vlan id run the command:
npu(config-srvcgrp-VPWS-Mapped)# config vid-map-range-end vlan-id
<size(1-4094)>.
IMPORTANT
When creating a new VPWS-Mapped service group, both start vlan-id and end vlan-id must be
defined.
NOTE
You can display configuration information for the service group. For details, refer to
Section 3.3.11.15.2.
Command
Syntax
npu(config-srvcgrp-VPWS-Mapped)# config vid-map-range-start vlan-id
<size(1-4094)>
npu(config-srvcgrp-VPWS-Mapped)# config vid-map-range-end vlan-id
<size(1-4094)>
Privilege
Level
10
Syntax
Description
Parameter Description Presence Default
Value
Possible
Values
vid-map-range-
start vlan-id
<size(1-4094)>
The start value of the range of
VLAN IDs for mapping.
None of the value within the
range shall overlap with any
existing infrastructue (host
interfaces) VLAN IDs. None
of the value within the range
shall overlap with VID
mapping ranges of other
existing Service Groups
Mandatory N/A 1-4094