User's Manual

Chapter 3 - Operation and Administration Using the CLI NPU Configuration
4Motion 289 System Manual
Command
Syntax
npu(config-srvcprfl-flow)# config ([flow-type <type (1)>] [cs-type <type
(1 | 4)>] [media-type <string>] [uldatadlvry-type <type(0<UGS> | 1<RTVR>
| 2<NRTVR> | 3<BE> | 4<ERTVR> | 255<ANY>)>] [ulqos-maxsustainedrate
<value(10000-40000000)>] [ulqos-trafficpriority <value(0-7)>]
[dldatadlvry-type <type(0<UGS> | 1<RTVR> | 2<NRTVR> | 3<BE> | 4<ERTVR> |
255<ANY>)>] [dlqos-maxsustainedrate <value(10000-40000000)>]
[dlqos-trafficpriority <value(0-7)>] [ul-rsrv-rate-min
<integer(0-40000000)>] [ul-latency-max <integer>] [ul-tolerated-jitter
<integer)>] [ul-unsol-intrvl <integer(0-65535)>] [dl-rsrv-rate-min
<integer(0-40000000)>] [dl-latency-max <integer>] [dl-tolerated-jitter
<integer>])
Privilege
Level
10
Syntax
Description
Parameter Description Presence Default
Value
Possible
Values
[flow-type
<type (1)>]
Denotes the type of flow, that
is, bi-directional (1) or
multicast (2).
multicast (2) is not supported
in current release.
Optional 1
 1: Indicates
bi-direction
al
[cs-type <type
(1 | 4)>]
Convergence Sublayer Type.
This parameter is applied to
both UL and DL Service
Flows.
Must match the type of
service group referenced by
ServiceGrpAlias during
creation of the flow: IPv4CS
should be selected if the
assigned Service Group is of
type IP. VLANCS should be
selected if the assigned
Service Group is of type
VPWS.
Optional 1
(IPv4CS)
 1: IPv4CS
 4: VLANCS
[media-type
<string>]
Describes the type of media
carried by the service flow.
Optional Null String, up to 32
characters