User's Manual

Chapter 3 - Operation and Administration Using the CLI NPU Configuration
4Motion 295 System Manual
3.3.11.15.3.3.5Deleting Uplink/Downlink Classification Rule Names
After enabling the service flow configuration mode, run the following commands to
delete uplink/downlink classification rules:
npu(config-srvcprfl-flow)# no ulclsf-rulename [<num_of_rulenames
(1-6)> <rulename> [<rulename>] ...]
npu(config-srvcprfl-flow)# no dlclsf-rulename [<num_of_rulenames
(1-6)> <rulename> [<rulename>] ...]
After you have executed these commands, you can terminate the service flow
configuration mode, and return to the service profile configuration mode (refer to
Section 3.3.11.15.3.3.6)
<rulename>
Indicates the name of the
uplink/downlink classification
rule to be linked to this
service flow. Use the
classification rule name to
reference the appropriate
classification rule.
For VLANCS service flows
the linked uplink and downlink
classification rules should be
the same. This is because the
VLANCS classificaion rules
define the CVID (Customer
VLAN ID), that should be the
same for uplink and downlink
flows.
The number of rule name
entries must match the
number defined in
num_of_rule_names.
For more information about
creating classification rules,
refer to
Section 3.3.11.15.4.1.
Mandatory N/A Valid
classification
rule name
Command
Modes
Service profile-service flow configuration mode