User's Manual

Chapter 3 - Operation and Administration Using the CLI NPU Configuration
4Motion 307 System Manual
3.3.11.15.4.3 Restoring the Default Parameters for the L3 Classification Rule
Run the following command to restore the default configuration for this
classification rule.
npu(config-clsfrule)# no [priority] [iptos-low] [iptos-high]
[iptos-mask] [iptos-enable][phs-rulename]
[iptos-high
<value(0-63)>]
Denotes the value of highest
IP TOS field to define the
highest value where the
range can end.
Cannot be lower than
iptos-low.
Can be modified only when IP
TOS classification is disabled
(see iptos-enable below). If
set to a value lower than
iptos-low, IP TOS
classification cannot be
enabled.
Optional 0 0-63
[iptos-mask
<value(0-63)>]
Denotes the mask for IP TOS
value.This mask is applied to
the TOS field received in the
IP header to be matched
within the TOS range
configured.
Optional 0 0-63
[iptos-enable] Indicates whether the use of
TOS-based classification is to
be enabled.
Optional By
default,
the use
of
TOS-bas
ed
classifica
tion is
disabled.
The
presence/abse
nce of this flag
indicates that
the use of
TOS-based
classification
should be
enabled/disabl
ed.
Command
Modes
L3 Classification rules configuration mode
NOTE
Refer to Section 3.3.11.15.4.3 for a description and default values of these parameters.