User's Manual

Chapter 3 - Operation and Administration Using the CLI NPU Configuration
4Motion 311 System Manual
3.3.11.15.4.4.4Terminating the Protocol Configuration Mode
Run the following command to terminate the IP protocol configuration mode:
npu(config-clsfrule-protocol)# exit
3.3.11.15.4.4.5Deleting Protocol Lists
You can, at any time, run the following command to delete all protocol lists:
npu(config-clsfrule)# no ip-protocol
3.3.11.15.4.5 Managing Source Address Configuration for the L3 Classification Rule
Classification rules can classify the packet, based on the source address of the
packet. You can configure the value of source address for a given classification
rule.
Command
Modes
L3 Classification rules-IP protocol configuration mode
Command
Syntax
npu(config-clsfrule-protocol)# exit
Privilege
Level
10
Command
Modes
L3 Classfication rule-IP protocol configuration mode
Command
Syntax
npu(config-clsfrule)# no ip-protocol
Privilege
Level
10
Command
Modes
L3 Classfication rule-IP protocol configuration mode
To configure one or more source addresses: