User's Manual

Chapter 3 - Operation and Administration Using the CLI NPU Configuration
4Motion 313 System Manual
3.3.11.15.4.5.2Configuring the Address Mask
After enabling the source address configuration mode, run the following command
to configure the address mask for the source address.
npu(config-clsfrule-srcaddr)# config [addr-enable] [addr-mask
<value>]
You can also run this command to enable a source address that is currently
disabled. For details, refer to “Disabling the Source Address” on page 314.
IMPORTANT
An error may occur if you provide an invalid source IP address. Refer the syntax description for
more information about the appropriate value and format for configuring this parameter.
Command
Syntax
npu(config-clsfrule)# srcaddr <ipv4addr>
Syntax
Description
Parameter Description Presence Default
Value
Possible
Values
<ipv4addr> Denotes the IPv4 address of
the source address for which
the configuration mode is to
be enabled. If you want to
create a new source address,
specify the value for the new
source address. The source
address configuration mode
is automatically enabled.
Mandatory N/A Valid IP
Address
Privilege
Level
10
Command
Modes
L3 Classification rules configuration mode
IMPORTANT
An error may occur if you provide an invalid address mask for the source address. Refer the syntax
description for more information about the appropriate value and format for this parameter.