User's Manual

Chapter 3 - Operation and Administration Using the CLI NPU Configuration
4Motion 315 System Manual
3.3.11.15.4.5.4Terminating the Source Address Configuration Mode
Run the following command to terminate the source address configuration mode:
npu(config-clsfrule-srcaddr)# exit
3.3.11.15.4.5.5Deleting Source Addresses
You can, at any time, run the following command to delete one or all source
addresses
npu(config-clsfrule)# no srcaddr [<ip-Addr>]
Privilege
Level
10
Command
Modes
L3 Classification rules-source address configuration mode
Command
Syntax
npu(config-clsfrule-srcaddr)# exit
Privilege
Level
10
Command
Modes
L3 Classfication rule-source address configuration mode
CAUTION
Specify the IP address if you want to delete a specific source address. Otherwise all the configured
source addresses are deleted.
Command
Syntax
npu(config-clsfrule)# no srcaddr [<ip-Addr>]
Privilege
Level
10