User's Manual

Chapter 3 - Operation and Administration Using the CLI NPU Configuration
4Motion 319 System Manual
3.3.11.15.4.6.3Disabling the Destination Address
Run the following command to disable the destination address that is currently
enabled:
npu(config-clsfrule-dstaddr)# no addr-enable
Syntax
Description
Parameter Description Presence Default Value Possible
Values
[addr-enable] Indicates that the use
of the associated
destination address is
enabled for the
classification rule that
you are configuring. If
the use of this address
is disabled, the
associated destination
address is ignored
while classifying the
packet.
Optional By default, the
use of the
associated
destination
address is
disabled.
The
presence/abse
nce of this flag
indicates that
the use of the
associated
destination
address is
enabled/disabl
ed.
[addr-mask
<value>]
Denotes the mask field
that is used to specify a
range of destination
addresses.
Optional 255.255.255.255 Valid address
mask
Command
Modes
L3 Classification rules-destination address configuration mode
Command
Syntax
npu(config-clsfrule-dstaddr)# no addr-enable
Privilege
Level
10
Command
Modes
L3 Classification rules-destination address configuration mode