User's Manual

Chapter 3 - Operation and Administration Using the CLI NPU Configuration
4Motion 323 System Manual
3.3.11.15.4.7.2Enabling the Source Port Range
Run the following command to enable the source port range:
npu(config-clsfrule-srcport)# port-enable
You can also run this command to enable a source port range that is currently
disabled. For details, refer to “Disabling the Source Port Range” on page 323.
3.3.11.15.4.7.3Disabling the Source Port Range
Run the following command to disable the source port range that is currently
enabled:
npu(config-clsfrule-srcport)# no port-enable
Command
Modes
L3 Classification rules configuration mode
IMPORTANT
If source port range is enabled, then:
IP protocol (protocol-enable) is set to enabled.
Protocol can be either 6 (TCP) or 17 (UDP).
For details on these parameters refer to Section 3.3.11.15.4.4.2.
Command
Syntax
npu(config-clsfrule-srcport)# port-enable
Privilege
Level
10
Command
Modes
L3 Classification rules-source port configuration mode
IMPORTANT
To enable this source port range, run the following command:
npu(config-clsfrule-srcport)# port-enable
For details, refer to “Enabling the Source Port Range” on page 323.
Command
Syntax
npu(config-clsfrule-srcport)# no port-enable