User's Manual

Chapter 3 - Operation and Administration Using the CLI NPU Configuration
4Motion 330 System Manual
3.3.11.15.4.11Clearing the configuration of the L2 Classification Rule
Run the following command to clear the configuration of this classification rule
(removing the configured cvid):
npu(config-clsfrule-L2)# no cvid
After clearing the configuration you can define a new cvid for this classification
rule.
3.3.11.15.4.12Terminating the L2 Classification Rule Configuration Mode
Run the following command to terminate the L2 classification rules configuration
mode:
npu(config-clsfrule-L2)# exit
Syntax
Description
Parameter Description Presence Default
Value
Possible
Values
cvid
<value(1-4094)
>
Denotes the Customer VLAN
ID value to be assigned to the
classification rule.
Mandatory N/A 1-4094
Command
Modes
L2 Classification rules configuration mode
Command
Syntax
npu(config-clsfrule
-L2)# no cvid
Privilege
Level
10
Command
Modes
L2 Classification rules configuration mode
Command
Syntax
npu(config-clsfrule
-L2)# exit
Command
Modes
L2 Classification rules configuration mode