User's Manual

Chapter 3 - Operation and Administration Using the CLI NPU Configuration
4Motion 334 System Manual
1 Enable the PHS rules configuration mode (refer to Section 3.3.11.16.1)
2 Configure the parameters for the PHS rule (refer to Section 3.3.11.16.2)
3 Terminate the PHS rules configuration mode (refer to Section 3.3.11.16.3)
You can, at any time, display configuration information (refer to
Section 3.3.11.16.5) or delete an existing PHS rules (refer to Section 3.3.11.16.4).
The following example illustrates the (sequence of) commands for enabling the
PHS rules configuration mode, configuring the parameters of a PHS rule, and then
terminating the PHS configuration mode, should be executed as shown in the
example below:
npu(config)# phs-rule phs-rule1
npu(config-phsrule)# config field
000000000000000000000000FFFFFFFF00000000 mask 000F00 verify 0 size
20
npu(config-phsrule)# exit
3.3.11.16.1 Enabling the PHS Rules Configuration Mode /Creating a New PHS Rule
To configure the parameters for a PHS rule, first enable the PHS rules
configuration mode. Run the following command to enable the PHS rules
configuration mode. You can also use this command to create a new PHS rule.
npu(config)# phs-rule <rulename>
If you use this command to create a new PHS rule, the configuration mode for this
PHS rule is automatically enabled, after which you can configure the parameters
for the PHS rule (refer to Section 3.3.11.16.2). You can then terminate the PHS
rules configuration mode (refer to Section 3.3.11.16.3) and return to the global
configuration mode.
To configure one or more PHS rules:
Command
Syntax
npu(config)# phs-rule <rulename>
Privilege
Level
10