User's Manual

Chapter 3 - Operation and Administration Using the CLI NPU Configuration
4Motion 352 System Manual
3.3.12.1.6 Deleting Backup Log Files from the NPU Flash
You can delete the backup log files from the NPU flash. It is recommended that
you periodically make a backup of these log files, and delete these from the NPU
flash.
To delete log and trace backup files from the NPU flash, run the following
command:
npu(config)# erase log file [<file name>]
Command
Modes
Global configuration mode
IMPORTANT
Trace and log messages are stored in the same backup file on the NPU flash. When you execute
this procedure, trace messages are also deleted from the NPU flash. For details, refer to
“Managing System-level Tracing” on page 667.
CAUTION
Specify the file name if you want to delete a specific backup file. Otherwise all the backup files
residing in the NPU flash are deleted.
IMPORTANT
An error may occur if:
 The file name that you have specified does not exist.
 A processing error has occurred.
Command
Syntax
npu(config)# erase log file [<file name>]
Privilege
Level
10