User's Manual

Chapter 3 - Operation and Administration Using the CLI NPU Configuration
4Motion 198 System Manual
3.3.10.1.4 Terminating the ACL Configuration Mode
To terminate the standard ACL configuration mode and return to the global
configuration mode, run the following command:
npu(config-std-nacl)# exit
To exit the extended ACL configuration mode and return to the global
configuration mode, run the following command:
npu(config-ext-nacl)# exit
3.3.10.2 Deleting an ACL
1 Check if the ACL is attached to the interface. For more information about this
command, refer Section 3.3.10.4.
2 Enable the interface configuration mode and de-attach the ACL. For details,
refer Section 3.3.10.3.
3 Terminate the interface configuration mode to return to the global
configuration mode (refer Section 3.3.10.3.4).
4 Run the following command to delete the ACL:
npu(config)# no ip access-list {standard <access-list-number
(1-99)> | extended <access-list-number (100-199)>}
Command
Syntax
npu(config-std-nacl)# exit
npu(config-ext-nacl) # exit
Privilege
Level
10
Command
Modes
Standard/Extended ACL configuration mode
To delete an ACL: