User's Manual

Chapter 3 - Operation and Administration Using the CLI NPU Configuration
4Motion 208 System Manual
3.3.11.1.1 Configuring the Next-hop IP Address
To map the next-hop IP address for a specific network ID, run the following
command:
npu(config)# idip <nw-id> <next-hop-ipaddr>
For example, run the following command to map the MAC address of the BS with
the next-hop IP address:
npu(config)# idip 112233445566 10.0.0.1
3.3.11.1.2 Deleting Next-hop IP Address-Network ID Mappings
To delete a specific or all next-hop IP address-network ID mappings, run the
following command:
npu(config)# no idip [<nw-id>]
NOTE
Refer to Section 3.3.11.2 for a list of existing next-hop IP address-network ID mappings.
Command
Syntax
npu(config)# idip <nw-id> <next-hop-ipaddr>
Privilege
Level
10
Syntax
Description
Parameter Description Presence Default
Value
Possible
Values
<nw-id> Denotes the BS ID. This
parameter is a MAC address,
and should be specified
without colons.
Mandatory N/A 6-byte ID
<next-hop-ipad
dr>
Denotes the next hop IP
address for a particular BS.
Mandatory N/A Valid IP
Address
Command
Modes
Global configuration mode