User's Manual

Chapter 3 - Operation and Administration Using the CLI NPU Configuration
4Motion 221 System Manual
If you use this command to create a new QoS marking rule, the configuration
mode for this rule is automatically enabled, after which you can execute any of the
following tasks:
 Configure the output parameters for bearer plane QoS marking rules (refer to
Section 3.3.11.11.2)
 Restore the default parameters for bearer plane QoS marking rules (refer to
Section 3.3.11.11.3)
After executing the above tasks, you can terminate the bearer plane QoS marking
rules configuration mode (refer to Section 3.3.11.11.4) and return to the global
configuration mode.
NOTE
The granularity of the QoS definition to be applied to packets transmitted on the bearer plane
depends upon the number of parameters that you specify. If any parameter is to be excluded from
the definition, specify the value 255 for that parameter.
Command
Syntax
npu(config)# bearerqos <qos-alias> [<intf-type((1<R3> - 0<R6>)| 255<ANY>)>
<
srvc-type(0<UGS> | 1<RTVR> | 2<NRTVR> | 3<BE> | 4<ERTVR> | 255<ANY>)>
<
trfc-priority((0-7)|255)> <media-type>]
Privilege
Level
10
Syntax
Description
Parameter Description Presence Default
Value
Possible
Values
<qos-alias> Denotes the QoS alias of the
QoS marking rule for which
you want to enable the bearer
plane QoS marking rules
configuration mode. If you
want to create a new QoS
marking rule, specify a new
alias and define the type of
interface, service, and traffic
priority that is applicable for
that rule.
Mandatory N/A String (1 to 30
characters)