User's Manual

Chapter 3 - Operation and Administration Using the CLI NPU Configuration
4Motion 237 System Manual
3.3.11.12.5 Deleting a Service Interface
You can, at any time, run the following command to delete service interface:
npu(config)# no srvc-intf [<intf-alias>]
3.3.11.12.6 Displaying Configuration Information for the Service Interface
To display configuration information for one or all service interfaces, run the
following command:
npu# show srvc-intf <intf-alias>
Privilege
Level
10
Command
Modes
QinQ Service interface configuration mode
NOTE
A Service Interface cannot be deleted if it is assigned to any Service Group.
A QinQ Service Interface cannot be deleted if it is assigned to a Service Flow (with a VPWS-QinQ
Service Group). For details refer to “Configuring Service Flows” on page 285.
Command
Syntax
npu(config)# no srvc-intf [
intf-alias>]
Privilege
Level
10
Syntax
Description
Parameter Description Presence Default
Value
Possible
Values
[intf-alias>
]
The alias of the Service
interface which needs to be
deleted
Mandatory N/A String
Command
Modes
Global configuration mode