User's Manual

Chapter 3 - Operation and Administration Using the CLI NPU Configuration
4Motion 239 System Manual
3.3.11.13 Configuring the AAA Client Functionality
The AAA client functionality enables configuration of one RADIUS client. The
RADIUS client encapsulates the messages destined for the AAA server in RADIUS
messages or decapsulates messages sent by the AAA server for the MS.
In addition, you can also configure certain RADIUS parameters such as the NAS
ID and the time zone offset that are applicable for all AAA clients. In the current
release a single AAA client is supported.
This section describes the commands for:
 “Managing AAA Client Configuration” on page 239
 “Managing Global RADIUS Configuration Parameters” on page 243
3.3.11.13.1 Managing AAA Client Configuration
1 Enable the AAA client configuration mode (refer to Section 3.3.11.13.1.1)
2 You can now execute any of the following tasks:
» Configure the AAA client parameters (refer to Section 3.3.11.13.1.2)
» Terminate the AAA client configuration mode (refer to
Section 3.3.11.13.1.3)
In addition, you can, at any time, display the AAA client configuration information
(refer to Section 3.3.11.13.1.4). The AAA client cannot be deleted.
Display
Format
VLAN
Service
Interface
% Asn-gateway Srvc Intf config
if-alias <string>
if-descr <string>
intf-type VLAN
if-vlan-id <value>
if-dflt-gw-ip <value>
Command
Modes
Global command mode
To configure the AAA client: