User's Manual

Chapter 3 - Operation and Administration Using the CLI NPU Configuration
4Motion 167 System Manual
3.3.9 Configuring Static Routes
Using the CLI, you can configure the static routes for traffic originating from the
NPU. For each static route, you can configure the destination IP address, address
mask, and the next hop IP address. The following are the types of traffic
originating from the NPU:
 R4/R6 control traffic
 R3 control traffic such as RADIUS or MIP
 NMS traffic
This section describes the commands for:
 “Adding a Static Route” on page 168
 “Deleting a Static Route” on page 169
Display
Format
(Standard)
Extended IP Access List 199
Access List Name(Alias) : 199
Interface List : NIL
Status : <Active|Inactive>
Admin-Status : <Up|Down>
Filter Protocol Type : <UDP|TCP>
Source IP address : <IP address>
Filter Source Port : <value>
Rule Action : QoS Marking
QoS Classifier ID : <value>
Marking rule status : <ACTIVE|INACTIVE>
...............
Command
Modes
Global command mode