Manualshelf

User's Manual

ManualsBrandsAlvarion Technologies ManualsElectronicsBreezeMAX 4Motion Broadband Wireless Access System
919293949596979899100
Chapter 3 - Operation and Administration Using the CLI NPU Configuration
4Motion 249 System Manual
In addition, you can, at any time, display configuration information (refer to
Section 3.3.11.14.10) or delete an existing service group (refer to
Section 3.3.11.14.9).
3.3.11.14.1 Enabling the Service Group Configuration Mode\ Creating a New
Service Group
To configure the parameters for the service group, first enable the service group
configuration mode. Run the following command to enable the service group
configuration mode or create the service group.
npu(config)# srvc-grp <grp-alias> [ServiceGrpType {IP | VPWS-QinQ |
VPWS-Transparent | VPWS-Mapped}]
If you use this command to create a new service group, the configuration mode for
this group is automatically enabled after which you can configure or restore the
default parameters for this service group.
After enabling the service group configuration mode, you can execute any of the
following tasks:
Configure the common parameters for an IP service group (refer to
Section 3.3.11.14.2)
Enable/Disable the VLAN Interface of an IP Service Group (refer to
Section 3.3.11.14.3)
Enable the service group operation mode and configure the DHCP
server/proxy/relay-specific parameters (refer to Section 3.3.11.14.4)
Configure the parameters of a VPWS-Transparent Service Group (refer to
Section 3.3.11.14.5)
Configure the parameters of a VPWS-Transparent Service Group (refer to
Section 3.3.11.14.6)
Configure the parameters of a VPWS-Transparent Service Group (refer to
Section 3.3.11.14.7)
After executing these tasks, you can terminate the service group configuration
mode (refer to Section 3.3.11.14.8).