User's Manual

Chapter 3 - Operation and Administration Using the CLI NPU Configuration
4Motion 250 System Manual
3.3.11.14.2 Configuring Common Parameters of an IP Service Group
After enabling the service group configuration mode for an IP service group, run
the following command to configure common parameters for the service group:
npu(config-srvcgrp)# config {{[srvcif-alias <service interface>]
[waitdhcp-holdtime <timeout>] [dhcp-ownaddr <ipv4addr>]} |
NOTE
You can display configuration information for specific or all service groups. For details, refer to
Section 3.3.11.15.2.
Command
Syntax
npu(config)# srvc-grp <grp-alias> [ServiceGrpType {IP | VPWS-QinQ |
VPWS-Transparent | VPWS-Mapped}]
Privilege
Level
10
Syntax
Description
Parameter Description Presence Default
Value
Possible
Values
srvc-grp
<grp-alias>
Denotes the group-alias of
the service group for which
the service group
configuration mode is to be
enabled. If you want to create
a new service group, specify
the group alias to be assigned
to the srevice group.
Mandatory N/A String (1 to 30
characters)
[ServiceGrpT
ype {IP |
VPWS-QinQ |
VPWS-Transpa
rent |
VPWS-Mapped}
]
The Service group’s type. Optional IP
 IP
 VPWS-QinQ
 VPWS-Trans
parent
 VPWS-Mapp
ed
Command
Modes
Global configuration mode